Is low pressure a problem for Shurflo 2088?
I have a Shurflo 2088 that I want to use to increase the pressure in the water tank. There will be an unlimited amount of water from the tank, but almost no psi. Is that going to be a problem? The Shurflo manual states: "If the water supply is limited or the flow rate is very low, the pump can re-pressurize the outlet faster than the liquid is released, resulting in a fast cycle." I could also potentially place the pump and pressure tank at a lower height, where it would have more head and slightly more psi.
Brock Omari commented
Pressure drops activate these pumps. When they reach a preset pressure, they will continue to pump. Consequently, a closed system must be used as the outlet. In order to fill a tank with them, I would think that you would have to be able to shut them off manually. You might be able to use a float switch to start/stop the pump.https://golireviews.com/
You have a lot of experience, and your answer helped me a lot to solve my problem. I have feeble water pressure in my house, and because of this problem, I have a terrible headache. I tried to solve this problem with my own hands but to no avail. So I decided to call the guys from one of the best plumbing services (https://www.wilcoplumbing.com.au/blocked-drains-northern-beaches/) who cope with blocked drains on northern beaches. They sent me a team of experts who solved all the questions regarding the plumbing needs. I am very grateful to these guys because they saved me from a lot of losses. In addition, they managed to cope with the loss that tormented me for several months in a matter of hours.
These pumps are activated by a drop in pressure. They will continue pumping until they reach a pre set pressure. That being said they need to output into a closed system. I would think that using them to fill a tank you would need to be able to manually shut them off. Possibly a float switch could be set up to start/stop the pump.
Karakurt Pictures commented
did not even think about this problem