I suggest Seeed...

Stackup information PCBs

Information about the stackup for a four-layer PCB.
I would be nice to have a stackup for every PCB thickness seeedstudio provides. This makes impedance based routing possible.

113 votes
Vote
Sign in
Check!
(thinking…)
Reset
or sign in with
  • facebook
  • google
    Password icon
    Signed in as (Sign out)
    You have left! (?) (thinking…)
    Ed shared this idea  ·   ·  Flag idea as inappropriate…  ·  Admin →

    3 comments

    Sign in
    Check!
    (thinking…)
    Reset
    or sign in with
    • facebook
    • google
      Password icon
      Signed in as (Sign out)
      Submitting...
      • robinmalhotra commented  ·   ·  Flag as inappropriate

        I bought a defective Blackwidow Ultimate some time ago, thinking that I would replace some switches and it would be fine. However, it turned out that the switches were fine, and there was a deeper problem.

        I searched the internet for my problem, and found some posts with similar cases, but no good solutions (just the usual baths in water and soap). A month or two ago, I started playing with it, and I was able to fix it.

        Since I wasn't able to find anything on the internet, I wanted to write my experience with the problem and how I fixed it, hoping that it will help someone with the same problem. I know it is quite long, but I wanted to leave everything clear, and I don't know how to write short texts. I hope it's readable. :P
        https://appsync.biz/speed-test/ https://appsync.biz/scrabble-word-finder/ https://appsync.biz/solitaire/

      • Morten commented  ·   ·  Flag as inappropriate

        I agree this would be useful for a low cost rough impedance control, or even for planning the trace widths and spacing when you plan to order impedance control.

      • Morten commented  ·   ·  Flag as inappropriate

        I agree this would be useful for a low cost rough impedance control, but as impedance control is a separate service, and for this I assume you will have to document stackup and routing widths/spacing.

      Feedback and Knowledge Base